The Scan Count Threshold represents the number of off-channel scan cycles the AP will wait before sending a Block Acknowledgment We recommend that this value be increased if you want to have only strong signals used in calculating locations.Įnter the Scan Count Threshold for Idle Client Detection value. This is the minimum level at which a data packet can be heard by the WSM modules for use in location calculations. In the Hyperlocation Config Parameters section:Ĭheck the Enable Hyperlocation check box.īased on AP and installed module, checking the Enable Hyperlocation check box enables different location service (PRL-based or AoA-based).Įnter the Packet Detection RSSI Minimum (dBm) value. Have the Cisco Hyperlocation radio module and are associated withĬhoose Wireless > Access Points > Global Configuration. This section contains the following subsections:Ĭonfiguring Cisco Hyperlocation Configuring Cisco Hyperlocation for all APs (GUI) This section provides instructions toĬonfigure Cisco Hyperlocation for all APs, a specific AP, and a group of APs that Submode wIPS is in enabled state, it is not possible to enable Hyperlocation This takes about 6 percent to 10 percent of
When Hyperlocation is enabled, a burst of BARs are sent for location purposes. Module go off-channel for about 100 milliseconds every 3 seconds. Hyperlocation configurations are not supported on Cisco APs in Sniffer mode.Ĭisco Hyperlocation in enabled state has an impact on performance where both radios of APs that do not have Cisco Hyperlocation Guidelines and Restrictions for Cisco Hyperlocation
#BEACON DESIGNER 8.1 SERIES#
The Cisco Hyperlocation Radio Module is supported on Cisco Aironet 36 Series Access Points.įor more information about Cisco Hyperlocation, see the following documents:Ĭisco CMX 10.2 Configuration Guide to enable Cisco Hyperlocation Therefore, sufficient airtime is available to support voice and video unless there is a case of extreme overload. For each 250 ms of dwell time, the primary AP schedules a 4ms-burst of BAR/BA every 9 ms. These APs send BAR/BA in a round robin fashion and onlyĥ to 6 percent airtime is used. In a typical AoA location usage, there are 4 to 5 participating APs.
#BEACON DESIGNER 8.1 DOWNLOAD#
The download BlockAckReq (BAR)/ Block Ack (BA) uses 1/3 of airtime in the worst case scenario when there is only one AP to Low latency location optimized channel scanning WSM and RRM channel scanning that is extended to 20-MHz, 40-MHz, and 80-MHz channel bandwidth. WSM Radio Module functions that are extended to: The Cisco Hyperlocation radio module provides the following: Configuring Access Points for HotSpot2 (CLI).Configuring Access Points for HotSpot2 (GUI).Configuring Mobile Concierge (802.11u) (CLI).Configuring Mobile Concierge (802.11u) (GUI).Debugging CCX Radio Management Issues (CLI).Viewing CCX Radio Management Information (CLI).Configuring Probe Request Forwarding (CLI).Modifying the NMSP Notification Interval for Clients, RFID Tags, and Rogues (CLI).Optimizing RFID Tracking on Access Points (CLI).
0 kommentar(er)
